ADEMCO 4160-12 C-COM Manuale Utente Scaricare il pdf (Pagina 3)

5. Plug theconnector into thereceptacle ontheback of the Console, making

sure that themnnector locks in place. Push theexcess wire back into the

wall, position the Console so the “U shaped cutouts on the back align with

the tabs on the mounting plate, and lower the Console into place until the

Iockingtabcticks. Toremovethe Console from themounting plate, repeat

the first half of step 3.

FLUSH MOUNTING

(Before proceeding, pedorm steps 1,2 & 4 of “SURFACE MOUNTING procedure.)

Locate the" Recess Mounting" template between wall studs, no less than

l-ll?from either stud. Dti113/8pi!ot holes inallfour corners andcutout7-

3/1 6“ x 3-7/W opening.

Open the information companment door and remove the card inside.

Remove the screw that secures the back cover (cover may be discarded).

Inseflthe screw andattach themetal clip as shown, Turn the screw until

theclip enters theguide postaboutl/8 inch. Insefithe straight end of the

spflng into the slot on the right side of the Console. Plug the connector

into the Console receptacle and push excess vjire back into wall.

Mth the metal clip in venical position, mount the console by hooking the

spring behind the right edge of the opening so that it holds the console

against theinside of the wall, Turn thescrew of themetalcfip. ~e clip will

turn until ithitsthe cfipstop andthenmovefomard. Continue turning the

screw until themnsole issnugagainst the wall. Make sure themnsoleis

straight, turn the screw and tighten the metal clip. DO NOT OVER

TIGHTEN!

Replace the card in the information compaflment.

SPRING

,..,.

CUr.eo

,.6)

I, ,hee!rockIS!.0

,“,.,

,..” break

CONSOLE

1 2 3 4 5 6 7 8 ... 23 24

Nessun commento

ADEMCO 4160-12 C-COM Manuale Utente Pagina 3