ADEMCO Security System Guida Utente Scaricare il pdf (Pagina 11)

Ð 11 Ð

SECURITY CODES

& AUTHORITY LEVELS

General

Information

At the time of installation, you were assigned an authority level

and a personal four-digit security code, known only to you and

yours. The security code must be entered when arming and

disarming the system. The authority level defines the system

functions that you can perform.

As an additional safety feature, other users that do not have a

need to know your code can be assigned different security

codes, and each user can be given a different authority level.

Users are identified by "user numbers", which are assigned when

assigning a user's security code.

All codes can be used interchangeably when performing system

functions within the limits of each code's authority level (a system

armed with one user's code can be disarmed by another user's

code), with the exception of the Operator Level C code. See

AUTHORITY LEVELS section on the following page for detailed

information regarding user authority levels.

Duress Code This feature is intended for use when you are forced to disarm or

arm the system under threat. When used, the system will act

normally, but can silently notify the central station of your

situation, if that service has been provided. The duress code is

pre-assigned by the installer during installation (auth. level 6).

Important: This code is useful only when the system is

connected to a central station.

Quick Arming Note that if "Quick Arming" was programmed by the installer, the

# key can be pressed in place of the security code when arming

the system. The security code must always be used to disarm

the system, however.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 65 66

Nessun commento

ADEMCO Security System Guida Utente Pagina 11