ADEMCO Security System Guida Utente Scaricare il pdf (Pagina 46)

Ð 46 Ð

TESTING THE FIRE SYSTEM

Fire Drill Test

(code + [#] + 69)

This test causes fire bells to be activated (in either steady

or pulsing manner as programmed in the system) for the

purpose of conducting a fire drill or a bell test. This test can

only be activated by the installer or a master user as

follows:

1. Enter the corresponding security code and press [#] +

69 (make sure the burglary portion of the system is

disarmed). Consoles will display "FIRE DRILL ACTIVE"

while this test is active.

2. The test may be stopped by entering any security

code and pressing OFF.

Note that the system continues to monitor all 24 hour

zones (fire, panic, etc.) while this test is active, and will

end the test when an alarm condition is detected. This

test should be conducted at periodic intervals as

determined by the local authority having jurisdiction.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 65 66

Nessun commento

ADEMCO Security System Guida Utente Pagina 46